The flush cutters work great for me here. Hammer it in 3 quarters of the way.īe mindful of how the wire cutters effect the ends of your wire. Light taps with your hammer should be enough to get the inlay set into the void. For curves, bend your wire to shape first, then set the inlay. Anything with teeth will damage your already soft metal. The wire inlay is also being held in with friction so there is no need to go overboard with the glue.īe sure to use jeweler's pliers on this step. But it the portion is long, lay a bead intermittently. ![]() If it is a small portion, lay the bead along the entire length (small = 1 - 3 inches). Lay a bead of superglue into the void that you are about to inlay. ![]() Otherwise, the metal will bend up and out of the void, ruining your work. Having multiple metal pieces instead of just one long connected piece provides room for expansion. ![]() There are a couple reasons for this:ġ) It is really difficult (impossible) to get sharp corners by bending wireĢ) Sanding (the next step) will cause the metal to expand. Your inlay should not be one continuous wire around sharp corners. ![]() Keep this in mind when choosing your design. Curves are rewarding but very time consuming. Straight lines are very easy to inlay and won't take you long at all. This is easily the most time consuming step, depending on your design.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |